Hondavert S300 – this is the most advanced emulator for OBD1, the only one in the world that supports two protocols for working with ECU. Make a hole in ECU case for USB Connector. Solder 28PIN connector or two 14PIN lines from installation pack. Solder 5PIN connector CN2 and 74HC373 IC from installation pack.ĬHECK YOURSELF: The notch on the chip must correspond to the notch on theīoard drawing Find place for external EPROM 27256. Have no polarity, soldered by either side. Solder 0,1 uF capacitors from installation pack. Solder J1 jumper and R54 resistor from installation kit. We need to modify eight components: C51, C52, R54, J1, J12, CN2, 74HC373, 27256 Fing places for J1 jumper and R54 resistor (they are near) on ECU board. The ECU inside should look similar to the picture. S300 installation kit (come with the original product).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |